The wiki is constantly being updated. If you have any question or suggestion, please send an email to our service mailbox
I/O devices
From NUUO Wiki
Contents |
Overview
Cameras are not the only element in a whole security system. A complete security system consists of
- Cameras
- NVR / DVR / Hybrid software or hardware
- Access control
- Burglar alarms
- Microphonic systems
- Cabling layout design
- Network planning
To control and receive signals from external devices, such as burglar alarms, you will need our IO boxes/cards to connect computers to external devices.
Different NUUO products need to be paired with different I/O devices.
| Type | Model name | Work with | |
|---|---|---|---|
| I/O box | box | SCB-C24, SCB-C26, SCB-C28 | SCB-1000, SCB-2000, SCB-3000, SCB-4000, SCB-5000, SCB-7000, SCB-IP+ |
| I/O card | card | SCB-G3-IO | SCB-1000, SCB-2000, SCB-3000, SCB-7000 |
Download
Specifications
- SCB-C08: USB to RS232/422/485 Converter
- SCB-C24: 16-ch Digital Output Insolated RS485 Module
- SCB-C26: 16-ch Digital Input Insolated RS485 Module
- SCB-C28: 4-ch Isolated Digital Input & 4-ch Power Relay Output RS485 module
- SCB-G3-IO: 4-ch Isolated Digital Input & 4-ch Power Relay Output with RS232 to RS 485 converter
Installation guide
C08 + C24/26/28
C24/C26/C28 must work with C08 (USB-RS485 converter) because general computer does not support RS485 interface directly.
1.) Plug C08 to USB port on the back of the PC and install C08 driver.
2.) Make sure the driver is installed successfully in device manager.
3.) Connect C24/26/28 to C08.(Take C08+C28 for example as below)
4.) Execute IOconfig.exe to check the COM port, Baud rate and starting address.
5.) Open Main console and go to [Config]->[Setting]->[I/O Device]
6.) Enter the desired name of [Module], specify the model of [Device], select the [COM Port], and [ID] of the device.
G3-IO
1.) Connect G3-IO card to power supply on computer.
2.) Connect G3-IO card to capture card via attached cable.(SCB-7000, SCB-3000, SCB-2000 and SCB-1000 card)
3.) Connect RJ-11 to COM port (RS-232) on back of PC for RS-485 application.
4.) Connect digital input/output devices to G3-IO card according to below diagrams.
Notice: Please DO turn off the power of PC before installing G3-IO card.
